All tables are 30”X48” all with 2 T-222 bases 1. Unload Booths & remove all booth Seats before moving booth into position. 2. Position booths according to plan locations with out seats adjust booths to indicated centers 3. Fasten booth to walls or floors as necessary 5. Clean all booth vinyl with Soap and water or household cleaner such as Windex, then apply to   all vinyl such as   such as “ ” ( Do not use “ ”   or other petroleum based products that will harm vinyl top coat. ) Assemble Table bases, and Install with 4 screws per base, do not over tighten screws each base should be installed as indicated. . 4. Install Seats. Vinyl Magic Armoral Set booths in approximate locations according to print. ( 72" centers should provide 16.5" - 17" from Booth back to table edge adjust for comfort desired ) ( mounting blocks in each corner of booth or to wall through bases ) vinyl spray wax 30” 48” 15” 9”-12” Installation Instructions 36” 18” 6” Varies Booth may be fastened to floor at each corner with appropriate fastening device, i.e. expansion bolt for concrete, lag bolt or screw wood floors. J.H. Carr and Sons Installation and Care instructions


8311 South 200th St., Kent, WA 98032
253-437-1355
800-523-8842
Fax: 253-437-1356